![]() ![]() ![]() Well, first of all, your blowers are controlled by an adjustable "blower/limit control". That really surprised me as i always worried to much wood would get me a runaway fire. I had trouble hitting 400 on the magnetic thermometer above the door last night with it fully loaded. It doesnt do that with a smaller load, burns nice then but doesnt burn long. I even got up, gave it more air and let the fire get going more before tamping it down again and got the same results. After awhile i'd hear the thermostat get low enough the blower fans would go off, then kick on a minute or three later, pretty much ran like that all night,cycling on and off instead of getting hot and staying on. Last night i really loaded the stove as full as i could get it(1st time i ever did this), let the fire get going good, by that time the flapper damper on the door was hot enough to be fully closed and useless so i had the ash spinner half way open and went to bed. No barometric regulator, seems to draft pretty good once its warmed up. Double wall pipe comes off a 45 from the stove, 4 ft over diagonally to another 45 into the wall and chimney and up a 20 ft uninsulated liner. First picture of the stove is when it was newly installed. Its been in a covered shed for 1 yr and averages about 16% on a moisture meter when i split a piece open. Wood is generally aspen, maple, box elder, black ash. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |